HumanTechnik cm-1 Instrucciones De Servicio página 31

No. Control feature
6 Stand
7 Frequency
selector switch
8 Battery compart- The battery compartment is located on the back of the
ment cover
Recording
9
device
pendant cord
Inserting the batteries into the CM-1 transmitter:
The device runs on two rechargeable "AAA"-type batteries. Where necessary,
only use original replacement batteries.
It can also run on non-rechargeable batteries. If you run your CM-1 communica-
tion system on disposable batteries, don't place the transmitter onto the CM
charger.
Function and application CM-1 transmitter
Fould-out stand
There is a slide switch on the back of the device for setting
the following 3 frequency ranges:
Switch A
setting B
C
Slide the selector switch to the required frequency position
using the supplied pin.
Bear in mind at all times that the CM-1 transmitter and
the CM-1 receiver have to be set to the same frequency
ranges. Different frequency ranges prevent each trans-
mission.
device and holds both batteries.
Insert the knob of the pendant cord into the circular part
of the device and engage the knob perceptibly by pushing
it towards he tip of the device.
863,500 MHz
864,000 MHz
864,500 MHz
English 31