Hoover Brave Manual De Instrucciones página 5

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
2. If it is not full, then;
A. Do the filters need cleaning? If so refer to 'Cleaning the filter'.
B. Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from telescopic tube or flexible hose.
Warning - The bag check indicator will turn red if the cleaner is used when the bag is full,
if there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of
time with bag check indicator is red, a thermal cut out will switch the cleaner off to prevent any
risk of overheating. The bag check indicator turn green once the cleaner has switched off to
signal that the thermal cut out has been activated. If this should happen, switch the cleaner off,
unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset.
ACCESSORIES AND NOZZLES
To obtain the best performance and energy efficiency
nozzles are used for the main cleaning operations. These nozzles are indicated in the
diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended for
occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as required
by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard floors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
All accessories can be fitted to the end of the handle or the end of the tube.
2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice
tool. By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored
neatly at the rear of the cleaner.
Crevice Tool – For corners and hard to reach areas.
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend
the brushes push the button on the body of the tool.
Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
*Certain Models Only ** Certain models only, nozzles may vary according to model
#1
it is recommended that the correct
3
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
Parquet Nozzle*– For wooden floors and other delicate floors.
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
USER CHECKLIST
should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
• Is the Filter blocked? Please refer to 'Cleaning the filter'.
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Quality
BsI IsO 9001
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
subject to change without notice.
GB
Tabla de contenido
loading

Tabla de contenido