Modifying Showview Programming - Samsung DVD-V70 Manual Del Usuario

VCR
Using the ShowView
GB
OK
Before presetting your DVD-VCR:
1
Up to six programmes can be preset.
Timer Method
Standard
1
ShowView
(DVD-V70)
2
Timer Method
If you want to set
the timer program,
press the key.
3
ShowView
Code
Code : 0 - 9
Correct :
4
5
6
™ ShowView is a trademark of Gemstar Development Corporation. The ShowView system is
STANDBY/ON OPEN/CLOSE
manufactured under licence from Gemstar Development Corporation.
5
34
(DVD -V80 /DVD -V85 Only)
Switch on both the television and your DVD-VCR
Check that the date and time are correct
Insert the cassette on which the programme is to be
recorded (safety tab intact)
To enter a , press the TIMER button.
ShowView
Press the or and OK or ❿ buttons to select ShowView
❷
Result: A message is displayed to allow you to enter the
ShowView code.
If all six programmes have been set, the message Timer
is displayed. Refer to page 37 if you wish to
is full
cancel a preset recording.
Press the numeric buttons to enter the code opposite the
programme that you wish to record in your television magazine.
If you wish to correct the ShowView code that you are
entering:
Press the ➛ button until the digit to be corrected is
cleared
Enter the correct digit
Press the OK button.
Result: The information concerning the programme is displayed.
When using the function for the first time with
ShowView
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the or buttons. Refer to the following page if:
❷
The programme number or times flash
You wish to modify the programme
If the programme and times are correct, press the RETURN button.
Press the STANDBY/ON button to activate the timer.
Refer to page 37 if you wish to:
Check that your DVD-VCR has been programmed correctly
Cancel a preset recording
The numbers next to each TV programme listing are
ShowView code numbers, which allow you to
programme your videorecorder instantly with the remote
control. Tap in the ShowView code for the programme
you wish to record.

Modifying ShowView Programming

If you wish to correct the programme displayed or modify certain elements, such as the recording speed, you
can do so before you press RETURN a second time to confirm.
If you wish to... Then...
Press the ➛ or ❿ buttons, until the
Select an input source other
than the tuner (AV1, AV2 or AUX) Press the INPUT SEL. button one or more times to change the
input source selection.
Result:
•
The input source must be selected before changing any other
value.
Press the ➛ or ❿ buttons, until the
Record a programme every day
(Monday to Sunday) at the same time Press the
displayed.
Press the ➛ or ❿ buttons, until the
Record a programme every week
on the same day and at the same time Press the
displayed, followed by the required day.
Example:
Press the ➛ or ❿ buttons, until the
Extend the recording time
Press the
time.
Press the ➛ or ❿ buttons, until the recording speed selection
Select the recording speed
mode.
Press the
displayed:
• Auto
(Auto Tape Speed Select) : see page 36
• SP (Standard Play)
• LP (Long Play)
VCR
PR selection mode.
The programme number is replaced by:
The AV1, AV2 or AUX source using the INPUT SEL.
button for a satellite tuner or external video source
Day selection mode.
or buttons, until the DLY (Daily) value is
❷
Day selection mode.
or buttons, until the W- (Week) value is
❷
W-SA (Weekly Saturday)
Stop selection mode.
or buttons to increase or decrease the stop
❷
or buttons until the correct indication is
❷
35
GB