17026855_1007 HS 45 NAFTA.book Seite 6 Montag, 29. Oktober 2007 10:42 10
ENGLISH
ENG
risk of disconnection of hedge trimmer cord from
the extension cord during operating:
i) Make a knot as shown in Figure 2 or
ii) Use one of the plug-receptacle retaining straps
or connectors described in this manual.
Volts
Ampere
rating
120 V
not
more
more
than
than
0
6
Figure 1
CORD
SET
(A) TIE CORD AS SHOWN
(B) CONNECT PLUG AND RECEPTACLE
Figure 2
10) Avoid Unintentional Starting – Don't carry
plugged-in hedge trimmer with finger on switch.
Be sure switch is off when plugging in.
11) Don't Abuse Cord – Never carry hedge trimmer
by cord or yank it to disconnect from receptacle.
Keep cord from heat, oil, and sharp edges.
12) Danger – Risk of Cut – Keep Hands Away From
Blades – Keep both hands on handles when power
is on.
Do not attempt to remove cut material nor hold
material to be cut when blades are moving. Make
sure trimmer switch is off when clearing jammed
material from blades. Do not grasp the exposed
cutting blades or cutting edges when picking up or
holding the hedge trimmer. Caution – blades coast
after turn off.
13) Don't Force Hedge Trimmer – It will do the job
better and with less likelihood of a risk of injury at
the rate for which it was designed.
14) Don't Over reach – Keep proper footing and
balance at all times.
15) Stay Alert – Watch what you are doing. Use
common sense. Do not operate hedge trimmer
when you are tired.
16) Disconnect Hedge Trimmer – Disconnect the
hedge trimmer from the power supply when not in
6
Total length of cord in feet
25
50
100
150
AWG
18
16
16
14
APPLIANCE
CORD
use, before servicing, when changing accessories
such as blades, and the like.
17) Store Idle Hedge Trimmer Indoors – When not
in use, hedge trimmer should be stored indoors in
dry, and high or locked-up place – out of reach of
children.
18) Maintain Hedge Trimmer With Care – Keep
cutting edge sharp and clean for best performance
and to reduce the risk of injury. Follow instructions
for lubricating and changing accessories. Inspect
hedge trimmer cord periodically, and if damaged,
have it repaired by an authorized service facility.
Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean, and free from
oil and grease.
19) Check Damaged Parts – Before further use of
the hedge trimmer, a guard or other part that is
damaged should be care fully checked to
determine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, breakage
of parts, mounting, and any other condition that
may affect its operation. A guard or other part that
is damaged should be properly repaired or
replaced by an authorized service center unless
indicated else where in this manual.
SAVE THESE INSTRUCTIONS
The trimmer shall not be used to cut stems
greater than 23/32 inch thick.
-------------------------------------------------------
------------------------------------------------------