Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Attach the hose coupler to the water port on your decks
Lubrication
surface. See Fig. 6-2.
4.
k.
j
Figure 6=2
5.
6.
Turn the water on.
While sitting
in the operator's
position
on the tractor, start
the engine
and place the throttle
lever in the FAST (rabbit)
position.
7.
Move the tractor's
PTO (Blade Engage) into the ON position.
8.
Remain in the operator's
position
with the cutting
deck
engaged
for a minimum
of two minutes,
allowing
the
underside
of the cutting
deck to thoroughly
rinse.
9.
Move the tractor's
PTO (Blade Engage) into the OFF
position.
10.
Turn the ignition
key to the STOP position
to turn the
tractor's engine
off.
11.
Turn the water off and detach the hose coupler
from the
water port on your deck's surface.
12.
Repeat steps 4 through
11 on the opposite
side of the
cutting
deck.
After cleaning your deck with the Smart Jet system, return to the
operator's
position
and engage the PTO. Keep the cutting
deck
running
for a minimum
of two minutes,
allowing
the underside
of the cutting
deck to thoroughly
dry.
_L
ARNING!
Before lubricating,
repairing,
or
inspecting,
always disengage
PTO, set parking
brake, stop engine and remove
key to prevent
unintended
starting.
FrontWheels
Each of the front wheel axles and rims is equipped
with a
grease fitting.
See Fig. 6-3. Lubricate
with a No. 2 multi-purpose
grease applied
with a grease gun after every 25 hours of tractor
operation.
/
/
.
J
Figure 6=3
Pivot Points & Linkage
Lubricate
all the pivot points on the drive system, parking
brake
and lift linkage at least once a season with
light oil.
I)eckWheels
Each of the tractor deck's front gauge wheels is equipped
with
a grease fitting.
Lubricate with a No. 2 multi-purpose
grease
applied
with a grease gun after every 25 hours of tractor
operation.
SECTION 6 --
MAINTENANCE
& ADJUSTMENTS
21
Tabla de contenido
