Ego Power+ LM2000-S Manual De Operaciones página 25

INSTALLING THE BLADE
WARNING: Always protect your hands by wearing heavy
gloves or wrapping the cutting edges with rags or other materials
when performing any maintenance on the mower blade. Always
remove the safety key and battery pack when servicing or
transporting the mower.
NOTICE: To re-install or replace the blade, be sure to replace the
parts in the exact order in which they were removed (Fig. 23).
1. Align the fan and the inner flange with the shaft and
assemble them in place.
2. While wearing protective gloves, position the blade on the
inner flange with the recess toward the mower (as shown
in Fig. 24).
3. Align the outer flange with the shaft and assemble it in
place.
4. While still wearing protective gloves, rotate the blade by
hand to align the round hole in the blade with the round
hole in the inner flange (Fig. 25).
5. Place a metal rod (e.g., a manual screwdriver) with
diameter less than 1/4 inch (6.35mm) into the aligned
holes to act as a stabilizer. Place another metal rod (e.g.,
a manual screwdriver) with diameter less than 7/16 inch
(11mm) into the fixing hole to act as another stabilizer.
6. Mount the bolt into the shaft, and turn it clockwise by hand
to pre-tighten it.
7. Use a 9/16 inch (14mm) torque wrench (not included) to
tighten the bolt clockwise. The recommended torque for the
blade bolt is 36-43 ft-lb (49-59Nm) (Fig. 26).
23
24
25
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2000-S
Fan
26
Align the two
round holes
Inner flange
Blade
Bolt
Outer flange
Recess
25