Tabla de contenido
Operating Instructions
3) The level of liquid disinfectant must be
Led 2
suffi cient (i.e. LED 2 on the keyboard must
be lit green)
Thatʼs all the information you need - you can
now step into the tub and enjoy the splendid
hydromassage that your Albatros tub can
provide.
8
How to operate the hydromassage system
The procedure described below shows the
sequence of operations required to use the
hydromassage system, and includes a few
useful tips.
Please remember that it is advisable to allow at
least two hours after a meal before enjoying a
relaxing massage.
First, switch the appliance on using the main
ON/OFF switch. Then fi ll the tub until the level
Led 1
of the water is 5 - 6 cm above the hydromassage
nozzles (LED L1 on the control keyboard must
be GREEN).
The ideal water temperature for an effective
hydromassage is very slightly above normal body
temperature, i.e. about 37°C.
The hydromassage system is factory-set for
a duration of 20 minutes. If desired, the cycle
can be repeated by pressing the WHIRLPOOL
and/or AIRPOOL keys (only for IDROTWO).
However, a twenty-minute cycle is more than
suffi cient to ensure the full benefi ts of the
hydromassage system; it should be borne in
mind that longer hydromassage treatments may
lower the blood pressure or cause excessive
muscular relaxation.
At the end of the hydromassage cycle, check
that all the nozzles are open and exit the tub
without draining the water (L1 GREEN); the water
can be used to clean the internal parts of the
Led 1
hydromassage circuit using the disinfection cycle
(see instructions for the disinfection cycle).
The disinfection cycle lasts about two minutes,
and cannot be interrupted. At the end of the
disinfection cycle, open the drain outlet to empty
the tub.
Manuale Uso VS ACEW / ACET - Code 10011523 - Edition 1 - 11/2007
IDROTWO version only:
At the end of the disinfection cycle, drain the tub.
To eliminate any residual water from the valves on
the bottom of the tub, press the AIRPOOL key.
This starts the electrical blower, which switches
off automatically after about one minute.
The disinfection cycle will be switched off if
the AIRPOOL key is pressed again during this
period.
At the end of the cycle, turn the main switch
to OFF.
It is advisable to sit or lie down for ten to twenty
minutes after a hydromassage in order to enjoy
the fullest effect.
9
Routine maintenance
Cleaning the Sanijet nozzles
In order to maintain perfect effi ciency, the nozzles
should be dismantled and cleaned at regular
intervals in order to remove any sediment or
scale.
Use the special wrench to rotate the nozzle
counter-clockwise until the internal ring can be
removed.
Extract the nozzle, dismantle and clean.
To replace the nozzle, perform the same
procedure in reverse.
Cleaning the suction nozzle
The suction nozzle features a special internal
device which prevents it from trapping hair and
other residue. This device should be checked
regularly in order to ensure complete effi ciency.
Using a cross-head screwdriver, remove the
screw and remove the fi lter plate from the nozzle.
Remove any residue by washing the parts with
water and a little bleach. Press the internal plate
gently with a fi nger and check that it moves
inwards by about 8 - 9 mm.
Replace the fi lter plate and the screw.
12
English
Tabla de contenido
