Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPTIMUM
M A S C H I N E N - G E R M A N Y
Summary of the pre-programmed standard values:
Parameter
LC-Display mode
resolution
decimal point
counting direction
Reset Delay
Attention! While the LC-display is off, the programmed
parameters remain valid. However of the voltage supply to
the battery in interrupted all parameters will be reset to the
"PowerOn" defaults.
Summary of the "PowerOn" default values:
Parameter
LC-Display Mode
resolution
decimal point
counting direction
Reset Delay
2.12 Parameter Description
Below, all parameters and functions of the electronic display are
explained. The column "Menu text PTM" showns the allocated text
display. For this purpose, the operating mode "PCon" is selected in
PTM (see User information "PTM").
2.13 LC-Display Mode
Beschreibung
The user wakes the LC-display by pressing the "on/off"
key. The LC-display is automatically switched off after the
next actuation of the "on/off" key of after 15 minutes of
inactivity.
ON
ON
The LC-display appears with sensor movements * or by
pressing the "on/off" key. The LC-display is automatically
switched off after the next actuation of the "on/off" key or
after 15 minutes of inactivity.
On with movement or on/off key
ON
LC-display is always on. The on/off key has no effect.
* The condition sensor movement is met as soon, as the sensor was
moved by at least 2,5 mm and no "ERROR" status exists (see chap-
ter "ERROR". Accordingly, there is inactivity when the sensor has not
been moved by 2,5 mm within approx. 15 min. The LC-display will
then be switched off.
10
Information
Wert
Display switches off and is reacti-
ved either by a sensor movement
or by pressing key "on/off".
0,1 mm
0,0
positive
off
Value
Display always on
0,1 mm
0,0
positive
aus
Menütext
PTM
"Lc.tA"
OFF
or
switch
OFF after 15
min.
"Lc.SE"
OFF
or
switch
OFF after 15
min.
"Lc.On"
Electronic display magnetic strip MA508 ; Version 1.0
Electronic display magnetic strip MA508
2.14 Resolution
2.14.1 Lineare Measurement:
Resolution
0,1 mm
1 mm
10 mm
2.14.2 Rotative Measurement:
Description
Resolution
(displayed value after
100 mm)
0,1 mm
1000
10 mm*
10
5 mm*
20
2,5 mm*
40
2 mm*
50
1,25 mm*
80
1 mm*
100
* These Stages are intended for rotative applications the account for
the factor spindle pitch in the electronic display.
Calculation of the displayed value
Display value
number
of poles
Examble:
Spindle pitch:
4 mm/per turn
Scale:
Magnetic ring
with 20 pols
Afer 10 revolutions (i. e. 40 mm in the travel direction) the value 40,0
shall be indicated on the display the measuring systems senses 10 x
20 poles (= 200 poles) over this distance.
Interpolation steps per pol
This corresponds to a resolution of 2,5 mm.
Menu text PTM
IP.50
IP.5
IP.0,5
Menu text PTM
Interpolation steps per
Pol
IP.50
IP.0,5
IP.1
IP.2
IP.2,5
IP.4
IP.5
Interpolation steps
per pol
Display value
number of poles
20. September 2011
Tabla de contenido
