Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Turn the cutting blade on itself. For that:
- Access through the top.
- Rotate the blade by the flank (not the edge) with a cotton swab, avoiding
cutting.
- Tighten screws 1 and 3.
4.
Blade replacing.
After 16000 cuts, for beeter precision, it is recommended to replace the
blade ( but it is not necessary). To do this, perform the following steps:
1. Loosen screws 1 and 2 using an Allen wrench. Then, remove the side
shield 3.
2. Remove screws 4 and 5 and pull out the container box of the blade.
3. Replace the blade and re-assemble, reversing the steps.
9
EN
Tabla de contenido
