Use; Switching On The Device; Selecting The Program - Beurer EM 39 Instrucciones Para El Uso

Where must the belt only be used:
Only use the belt around your stomach and
back. Your navel should be covered by the
middle of the belt.
Automatic deactivation
If the device is not used after it is switched on, it switches off automatically after 5 minutes.

6. Use

General information about training with the abdominal and back muscle belt
In the first week, the abdominal and back muscle belt should not be used more than once a day, in order to
allow your muscles to slowly adjust to the device. After the first week, you can train more often.
Note: To allow your muscles to recover, you should rest for at least 5 hours between training sessions.
The intensity of training can be matched to your personal fitness level in this way. It is nonetheless recom-
mended to proceed through a program one step at a time. The programs A to E are coordinated so that
your muscles are given sufficient time to adapt to more intensive training with each application. Programs
A to E differ in their frequency, period of the training pulses, pause between the training pulses.
The device is set with a training plan so it works through the programs A to E and repeats each program a
different number of times. You can select the program yourself however.
How to train correctly
What you feel when training
At the beginning of the training session you will feel a slight tingling sensation. With increasing intensity
you will feel muscle contractions in the surrounding area and directly under the electrodes.
Each contraction starts with a slow rise in voltage; this is held for several seconds at the set intensity. The
muscle then relaxes again gently.

Switching on the device

Press the On/Off switch. A short signal sounds and the LCD lights up. Program A is activated the first time
the device is started.

Selecting the program

The abdominal and back muscle belt has five coordinated programmes that you can run through in a
training period of several weeks. You can start the first week with programme A at a low level and increase
your training with growing strength in your muscles. The abdominal and back muscle belt is set so that
after a certain number of training cycles, the next higher programme is automatically set. However, you
can also choose the programme yourself, depending on your well-being and fitness level.
Observing the training cycle
Each training session consists of three phases:
― a warm up phase (30 Hz) of two minutes duration, which prepares the muscles for training
― a training phase (at a different frequency depending on the training program)
― a relaxation phase (30 Hz) of two minutes during which the muscles can relax again
Program Running time [min]
A 22
B 22
C 22
D 31
E 31
navel
Repetitions Training frequency [Hz]
4 45 / 60
4 60 / 80
8 45
16 60
continuous 80
14