Functional Test; Test Equipment; Test Setup - R&S Z3 Manual Del Usaurio

®
R&S -Z3
4

Functional Test

This chapter provides information on executing performance tests. The required
equipment, the test procedure and the detailed test goals are described.
4.1

Test Equipment

Item Type of equip-
ment
1 Vector Network
Analyzer
2 RF-Cable
3 Calibration kit
4.2

Test Setup

To set up the performance test
1. Screw the antenna head into the (fixed) monopole until it locks.
2. Connect the N connector of the RF cable to port1 of the network analyzer.
3. Connect the BNC connector of the RF cable to the output jack of the antenna.
4. During the measurement procedure, make sure that no (metallic) objects are
located within a radius of 3 meters in every direction.
Manual 5202.9444.02 ─ 01
Recommended characteristics or features
9 kHz to minimum 1 GHz
Length 5 m, Cable type RG400, Connector N
to BNC
Open, short and match for one port calibration e. g. R&S ZV-Z170
Functional Test
Test Setup
Recommended
model
e. g. R&S ZVRE,
R&S ZNB
N (male),
1317.7683.02
7