How To Stop The Engine; To Start Engine; Cold Start - Craftsman 536.887750 Manual Del Usario

[i] ".l _ 1:7±'1 / [e]_
HOW TO STOP THE ENGINE
1. To stop the engine, move the
throttle control lever to the "SLOW"
position, then move to the "STOP"
position (see Figure 20).
Choke Knob
!
Figure 20
2. Pull out and remove the ON/OFF
key (see Figure 21). Keepthe
ON/OFF key in a safe place. The
engine will not start without the
ON/OFF key.
f ( =F Key
Figure 21
TO START ENGINE
Be sure that the engine has sufficient
oil. The snow thrower engine is
equipped with a recoil starter. Before
starting the engine, be certain that you
have read the following information.
COLD START
1. Be sure auger drive and traction
drive levers are in the disengaged
(RELEASED) position.
2. Turn the rotary choke knob to the
CHOKE position (see Figure 22).
3. Depress the primer button three
times (see Figure 22).
4. Move throttle control to "FAST"
position. Operate the engine with
the throttle control in the "FAST"
position (see Figure 23).
Throttle Control
Figure 23
5. Remove the ON/OFF keys from the
plastic bag. Insert one of the
ON/OFF keys into the key slot (see
Figure 24). Make sure the key
snaps into place. Do not turn the
ON/OFF key. Keep the second ON/
OFF key in a safe place.
#
f _ ON / OFF Key
Figure 24
6. (RECOIL START) Pull the starter
handle rapidly (see Figure 25). Do
not allow the handle to snap back,
but allow it to rewind slowly while
F-011068L 16