Craftsman 536.887750 Manual Del Usario página 10

How To Install The Speed Control Rod
1. Put the speed select lever into the
sixth gear position.
2. Attach the speed control rod (end
with 90 °bend) to the speed select
bracket with washer and cotter
pin. See Figure 9.
3. Put the speed select lever into the
first gear position.
4. Attach the ball joint, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 10. The fasteners are
attached to the ball joint at the
factory.
5. The length ot the ball joint and
speed control rod have been pre-
adjusted at the factory. If an adjust-
ment is required, loosen the nut.
Remove the fasteners to discon-
nect the ball joint from the shift
yoke assembly. To lengthen or
shorten the speed control rod, turn
the adapter to obtain the correct
length.
6. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed Select
Speed Lever
Select
Bracket
Cotter Pin
Speed
Control
Rod
Figure 9
Speed Control Rod
Shift Yoke Assembly
Ball" "2 \
Joint _x Fasteners
Figure tO
How To Assemble The Chute Deflector
1. Remove the carriage bolt. See
Figure 11.
2. Raise the chute deflector into op-
erating position,
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Chute
Deflector
Carriage
Bolt Flang_,_Washer Nut
Figure 11
F-011068L 10