Craftsman 536.888110 Operator's Manual página 11

How To Set The Skid Height
The snow thrower is equipped with
height adjustable skids mounted on
the outside of the auger housing. See
Figure 13. To adjust the height of the
skids, see To Adjust Skid Height para-
graph in the Service And Adjustment
section
AdjI Figure 13
How To Set
The Length Of The Cables
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment section.
_-" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
_' All assembly instructions have been
completed.
v' The discharge chute rotates freely.
_' No remaining loose parts in carton.
_' Check the fasteners. Make sure all
fasteners are tight.
v' Check the air pressure of the tires.
Correct air pressure is from 14 to 17
PSI. See the side of the tire for maxi-
mum inflation. Do not exceed maxi-
mum inflation.
_' On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un-
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_' Engine oil is at proper level. Use a
high quality detergent oil classified
"For Service SG, SH, SJ, SL, or
higher".
_' Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline
with a minimum of 85 octane.
_" Become familiar with all controls-
their location and function. Operate
controls before starting engine.
F 0410110L 11