PowerWalker VFD 400 Guia De Inicio Rapido página 5

2. Installation and operation
Inspection
Remove the UPS from its packaging and inspect it for damage that may have occurred during
shipping. If any damage is discovered, repack the unit and return it to the place of purchase.
Charging
This unit is shipped from the factory with its internal battery fully charged, however, some
charge may be lost during shipping and the battery should be recharged prior to use. Plug
the unit into an appropriate power supply and allow the UPS to charge fully by leaving it
plugged in for at least 10 hours with no load (no electrical devices such as computers,
monitors, etc.) connected.
Placement
Install the UPS unit in any protected environment that provides adequate airflow around the
unit, and is free from excessive dust, corrosive fumes and conductive contaminants. Do not
operate your UPS in an environment where the ambient temperature or humidity is high.