Special Safety Instructions - Rothenberger HD 11/90 Instrucciones De Uso

15 Pull the plug from the socket. When not using the electric tool, before maintenance or
when changing tools, such as saw blades, drills and cutting bits.
16 Do not leave any tool keys inserted. Before switching on, check to see that keys and ad-
justment tools have been removed.
17 Avoid unintentional activation. When plugging the tool in, make sure that the switch is
turned off.
18 Use outdoor extension cords. When outdoors, use only extension cords that are approved
and appropriately marked.
19 Be alert. Pay attention to what you do. Approach your work sensibly. Do not use the electric
tool when you are distracted.
20 Check the electric tool for damage. Before using the electric tool, you must inspect safety
equipment or slightly damaged parts carefully to ensure that they work properly and as in-
tended. Check to see that the moving parts operate freely and don't stick, and to make sure
no parts are damaged. All parts must be mounted properly and meet all the conditions for
ensuring trouble-free operation of the electric tool.
Damaged safety equipment and parts must be properly repaired or replaced by a profes-
sional facility, unless otherwise indicated in the user manual. Damaged switches must be
replaced by a customer service facility.
Never use an electric tool whose switch cannot be turned on and off.
21 Caution. Using other insertion tools and accessories may cause injury.
22 Have your tool repaired by an electrical expert. This electric tool meets applicable safety
requirements. Repairs must be made only by an electrical expert using original replacement
parts. Otherwise accidents many occur.
1.3

Special safety instructions

In accordance with DIN 1988-1 the devices must not be connected directly to the public drinking
water supply. According to the DVGW (German Technical and Scientific Association for Gas and
Water) short-term connection is, however, permissible if a return flow inhibitor with an aerator is
fitted in the inlet pipe.
Hose lines are to be guided in such a way that they are not pinched or damaged by bodies with
sharp edges. Extended tensile and bending stress to the hose lines is to be avoided.
The operator must ensure that the proper condition of the important parts and safety devices is
checked every time before the fluid spray gun is put into operation. Any faults are to be reme-
died before start-up.
For pipe cleaning work do not switch on until the nozzle and the hose are inserted into the pipe
until the mark on the pipe. Please also observe the "Guidelines for fluid spray guns" and "Safety
of electric devices for domestic use and similar purposes".
Never take in solvent-containing fluids such as paint thinner, petrol, oil or similar fluids. Observe
the information provided by the manufacturers of the additives. The seals in the device are not
solvent resistant. The atomised spray of solvents is highly inflammable, able to explode and tox-
ic.
This appliance was designed to be used with detergents which are supplied or recommended by
the manufacturer. The use of other detergents or chemicals may compromise the safety of the
appliance.
The high pressure jet may not be directed at persons, animals, live electrical equipment or at the
appliance itself.
Do not use the appliance when there are other persons around unless they are also wearing
protective clothing.
The high-pressure jet must not be directed at other persons or the user him/herself to clean
clothing or footwear.
Do not spray flammable liquids.
The appliance must not be operated by children or persons who have not been instructed ac-
cordingly.
12 ENGLISH