Search Mode - ProMed ACP Instrucciones De Manejo

P440010_ACP_promed_West.qxd:Akupunkturgerät
GB
3 Operation

3.1.2 Search mode

Apply the tip to the skin with light pressure - in the approximate area where the
acupuncture point should be located (see accompanying book). When you begin
searching, the audio signal will become brighter, and one or more LEDs will light up
on the display the closer you come to an acupuncture point. Search for the point with
the tip until the audio signal is at its brightest and the most diodes are illuminated.
NOTE
Sometimes acupuncture points are located very close to one another.
In order to find the right point for the desired treatment, always
refer to the accompanying acupuncture book or specialized literature.
3.1.3 Manual treatment
Once you have found the acupuncture point, press the stimulation button with your
index finger and keep it depressed. The audio signal ceases and the LED begins
blinking; at the same time the first LED in display blinks continuously. You are now
treating the acupuncture point with the lowest electric current (basic setting). If you
wish to increase the intensity, it is recommended to keep the tip on the acupuncture
point and to change the intensity setting (see also "Adjusting the intensity"). As soon
as you release the stimulation button, the stimulation ceases and the device returns to
search mode. Therefore you yourself determine how long the electrical impulses are
transmitted.
3.1.4 Treatment with automatic timer
By means of an internal clock the promed ACP can be set for 30 seconds or 60 seconds
of stimulation using time selection button. The set time is retained until it is changed
by pressing the time selection button or until the device is switched off. In the basic
setting, as soon as you turn on the device, the manual mode is always activated first.
Before searching for the acupuncture point, set the desired time by pressing the time
selection button: press once for 30 seconds, and press again for 60 seconds. The LED
displays the respective setting.
Search for the acupuncture point (see "Search mode") and briefly press the stimulation
button once. The LED begins to blink. Since you do not have to keep the stimulation
button depressed, you can comfortably hold the device on the acupuncture point with
light pressure.
After the set time has expired the device returns to the search mode. Since the time
setting is retained, you can stimulate the point again for the same set time by again
briefly pressing the stimulation button.
22
26.02.2011 8:46 Uhr Seite 22