Fitting The Camera - Dometic PERFECTVIEW CAM 301 Instrucciones De Montaje Y De Uso

PerfectView
Therefore, please observe the following instructions:
•
Wherever possible, lay cables inside the vehicle, as they are better protected there than out-
side.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
•
To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters,
etc.). Use corrugated piping or other protective materials to protect against mechanical wear.
•
When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 2, page 2).
•
Attach the cables securely in the vehicles to prevent tripping hazards. This can be performed by
using cable binders, insulating tape or gluing in place with adhesives.
•
Protect every through-hole made in the bodywork against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the cable sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all installation work on the
camera and have laid the required cable lengths.
8

Fitting the camera

A
NOTICE!
Select a location for the camera and attach it firmly enough so that it cannot under any
circumstances fall off and injure bystanders (e.g. by being knocked off by branches
brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities. This
authority must note any such changes your vehicle documents.
Note the following instructions during installation:
•
To provide a suitable viewing angle, the camera must be attached at a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
•
Make sure that the installation location of the camera is sufficiently firm (e.g. to prevent the
camera from being knocked down by branches that may brush the roof of the vehicle).
Always use the supplied insulation pad (fig. 3 3, page 2). This prevents residual currents due
•
to bad ground connections in the vehicle. Residual current can cause lines of interference in the
picture or buzzing in the loudspeakers or even damage components.
EN
Fitting the camera
11