Optional Accessories - Makita 4604D Manual De Instrucciones

MAINTENANCE
CAUTION:
• Always be sure that the controller is switched off and
the connection cord is disconected from the shears.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Blade maintenance (Fig. 20 & 21)
NOTE:
• Before and after operation, check the shear blades
carefully.
After operation, clean off the blades with a stiff brush.
Then wipe the blades with a cloth and coat them with
machine oil.
CAUTION:
• Failure to perform blade maintenance may cause
excessive blade friction and shorten the operating time
per battery charge.
Sharpening blades
Upper shear blade
Apply the flat surface of the diamond file to the blade
edge. Push the diamond file in the direction of the arrow
to sharpen along the entire blade edge. Maintain the
same flat contact with the file consistently along the
entire blade edge. (Fig. 22)
Apply the flat surface of the diamond file lightly to the
reverse side of the blade. Move the diamond file in the
direction of the arrow to remove burrs. (Fig. 23)
Lower shear blade
Apply the round surface of the diamond file to the blade
edge. Push the diamond file in the direction of the arrow
to sharpen along the entire blade edge. (Fig. 24)
Apply the flat surface of the diamond file lightly to the
opposite side of the blade. Move the diamond file in the
direction of the arrow to remove burrs. (Fig. 25)
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by Makita
Authorized Service Center.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. The accessories or
attachments should be used only in the proper and
intended manner.
• Upper shear blade
• Lower shear blade
• Battery 4600
• Charger DC4600
• Controller C4600
• Connection cord
• Diamond file
• Machine oil
• Socket wrench 3 – 13 (with hex wrench) • Waist belt
• Suspenders
• Holster
• Arm band
• Plastic carrying case
• Battery cover
NOTE:
• Some items in the list may be included in the tool pack-
age as standard accessories. They may differ from
country to country.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K): 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Vibration emission (
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been mea-
sured in accordance with the standard test method and
may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the oper-
ator that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to
the trigger time).
ENG905-1
): 70 dB (A) or less
pA
ENG900-1
2
or less
): 2.5 m/s
a
h
2
ENG901-1
11