Materials And Tools For Installation - WEG Motor Scan Manual General De Instalación Y Operación

www.weg.net
7. Select the application:
Select the application where the motor is installed.
There is a list of the most common applications.
If you cannot find your application, select "other" and
enter your application manually.
8. Select the voltage:
Select the motor supply voltage.
It contains a list of the supply voltages supported for the
serial number of the motor that was previously registered.
Select whether the motor uses an inverter.
9. Synchronization:
In order to finish, wait for the data to synchronize, staying close to the sensor
until the process is finished. Your mobile device will need an internet connection
for this last step. Make sure the sensor is not already registered in another plant.
Enter the WEG IoT Platform to check if the sensor appears in the motor plant.
From now on, the sensor will be correctly configured and appear on the APP home screen.
Synchronize periodically to download the scheduled measurements.
ATTENTION!
Depending on the device model and/or software version, the connection between the mobile device
and the sensor may not be established. In this case, it is recommended to use another device to make
the connection.

7.4. MATERIALS AND TOOLS FOR INSTALLATION

Materials and tools required to install the sensor on the motor:
Sensor Screw M4x20 mm
Figure 7.2 – Tools and materials required to install the sensor on the motor
54 Manual of Electric Motors
Drill Bit 5,9 mm Hammer
or 15/64"
Allen Wrench 3 mm Drill Bushing