Tristar SM-6000 Manual De Usuario página 16

UK
Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz.
Connecting to the power source
Get the adaptor (no. 15) and the foot pedal (no. 16).
1. Connect plug "A" to the machine and plug "B" into the wall outlet
2. Turn on power switch "ON".
3. Connect the foot control "C" to the machine.
4. The speed of the machine can be regulated by applying pressure to the foot controller.
Press the main switch to "ON" for power, the sewing light will burn.
On/off switch
Insert or change the needle
Attention: Turn power to "off" position before inserting the needle, to avoid electrical shock.!
Change the needle regularly, especialy if it is showing signs of wear and causing problems.
Insert the needle as follows:
Turn the handwheel (no. 11) to top position.
Loose the needle clamp screw(no.7) and tighten again after inserting the new needle.
The flat side of the needle should be towards the back. Insert the needle as far up as it will go.
Take out of the needle Inserting the needle
15