Gaggenau DF 260 Instrucciones De Manejo página 18

Stainless steel appliances: To prevent corrosion, avoid using sponge
cloths or wash them out thoroughly several times before using for the
irst time.
Filters
The ilters keep large foreign objects in the rinsing water away from the
pump. These foreign objects may occasionally block the ilters.
The ilter system consists of a coarse ilter, a lat ine ilter and a
microilter.
• After each washing cycle check the ilters for residue.
• Unscrew ilter cylinder as illustrated and take out ilter system.
• Remove any residue and clean ilters under running water.
• Re-install ilter system in reverse sequence and ensure that the
arrow marks are opposite each other after closing the ilter system.
CAUTION
To avoid injury, do not reach into the large object trap with your
ingers. The large object trap could contain sharp objects.
Spray arms
Limescale and contaminants in the rinsing water may block nozzles
and bearings on the spray arms. Using the water softening system may
reduce this.
• Check outlet nozzles on the spray arms for blockages.
• Unscrew the upper spray arm.
• Remove the lower spray arm.
Waste water pump
Large food remnants in the rinsing water not retained by the ilters may
block the waste water pump. The rinsing water does not get pumped
out and covers the ilter.
In this case:
• Disconnect the appliance from the power supply.
• Remove the ilters.
• Scoop out water, use a sponge if required.
• Using a spoon, pry off pump cover(as illustrated) until it clicks, then
grip the cover by the lug and irst pull it upwards until it resists and
then pull it out forwards.
• Check inner compartment and remove any foreign objects.
• Place cover in the original position, press down and engage.
• Install ilters
18
1
2
1
3
2
Klick