HSM Securio B24 Instrucciones De Servicio página 14

Other function modes
• Permanent mode
Application: Destroying large quantities of
paper
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down
and the shredder switches to standby.
Start: Press the operation button for three
seconds.
Premature cancellation: Press the
operation button.
6 Troubleshooting
Display Problem
Paper
jam
Continu-
ous lamp
Overload • The motor was overloaded. Let the shredder cool down for approx.
Flashing General
light fault
displays
Shredded
material
container
full
Container
open
14
Measure
You have fed in too much paper.
 The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
15 – 20 mins. before using it again.
• A fault has occurred while shedding paper.
Pull the paper out of the slot to clear the light barrier.
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus.
• Insert the shredded material container correctly in the base cabinet.
SECURIO B 24
english
• Stand-by mode
Function: Two minutes after the last pa-
per feed operation, all consumers that are
not required are switched off automati-
cally.
The „Ready for operation" indicator fl ash-
es briefl y at regular intervals.
The shredder starts automatically when
paper is fed in.
12/2014