Rautheon UW50PV Manual De Operation página 45

Each time the Warm key is pressed, one hot
and one cold water valve is turned on. The
machine is equipped with four water valves
(two fill and two spray); thus pressing the
Warm key twice will turn on all four valves
and reduce fill times.
Use the following procedure to program a
fill to a specific temperature:
1. The computer must be in PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Cold key. If this is the second
step of hypothetical cycle 25, the display
will read "C-0225." (HOT or WARM may
be programmed instead to control inlet
valves during the first three seconds of the
fill. After the first three seconds, the fill is
the same regardless of the prompt.)
3. Press the key representing the desired
water level (Low, Medium, High, or
Over). If High is pressed, for example,
the display will read "CH0225."
4. Press the Heat key. The display will read
either "080F25" or "025C25," depending
on whether Fahrenheit or Centigrade
is prompted.
Enter the desired fill temperature. Three
digits must be entered. If the desired
temperature is less than 100 degrees,
the first digit must be 0. If 100 degrees
Fahrenheit is selected, the display will
read "100F25."
The valid temperature range is 80 – 200
degrees Fahrenheit and 25 – 93 degrees
Centigrade. The computer will not accept
temperatures out of this range. (The fill
temperatures possible are governed by the
temperature of the available hot water.)
F232050
Programming
5. Press the Enter key. The display will read
"M---S." Now assign the maximum time
to be allowed for reaching the fill level in
minutes and seconds.
6. Press the Enter key, and go to the next
step in the cycle.
The computer will attempt to maintain the
temperature within a margin of plus or minus
5 degrees of the target fill temperature during
such a step.
43