Cleaning And Maintenance; Maintenance; Cleaning; Grease Filter - Beko CHS 30100 SS Manual De Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

6

Cleaning and maintenance

6.1 Maintenance

Before performing any maintenance
operation, isolate the hood from the
electrical supply by switching off
C
at the connector and removing the
connector fuse.
Or if the appliance has been
connected through a plug and
socket, then the plug must be
removed from the socket.

6.2 Cleaning

• Do not spray cleaners directly to the control
while cleaning the Hood.The cooker hood
should be cleaned regularly (at least with the
same frequency with which you carry out
maintenance of the fat filters) internally and
externally. Clean using the cloth dampened with
neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out
A
the basic cleaning recommendati-
ons of the cooker hood and repla-
cement of the filters may cause fire
risks.
• Therefore, we recommend oserving these
instructions.
• The manufacturer declines all responsibility for
any damage to the motor or any fire damage
linked to inappropriate maintenance or failure
to observe the above safety recommendations.

6.3 Grease Filter

Traps cooking grease particles.
This must be cleaned once a month using non
aggressive detergents, either by hand or in
the dishwasher, which must be set to a low
temperature and a short cycle. When washed
in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering
capacity.
Range Hood / User Manual
To remove the grease filter, pull the spring release
handle.

6.4 Replacing the light bulb

Before replacing the lamps, switch
C
power off at service panel and
lock service panel disconnecting
means to prevent power from being
switched on accidentally.
Turn off the lights and fan. Allow
C
the lights to cool before handling.
If new lights do not operate be sure
lights are inserted correctly before
calling service.
Replace Lights
• Remove the damaged light (twist counter
clockwise) and replace with a new 120 Volt, 50
Watt (maximum) 50° halogen light made for a
GU10 base, suitable for use in open luminarie.
17 / 56 EN
Tabla de contenido
loading

Tabla de contenido