Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Insert the non-serrated side of the band saw blade
into the upper holder and lower holder. Make sure the
band saw blade in both upper and lower holder touches
to the bottom bearings.
2
► 1. Lower holder 2. Upper holder 3. Bottom bearing
4.
With pressing the middle part of the band saw
blade, position the blade around one wheel. Moving the
wheel to A side makes it easier to do so.
1
A
► 1. Wheel 2. Rubber tire
5.
Position the band saw blade on another wheel
similarly.
6.
Position the edge of the band saw blade on rubber
tire.
7.
Hold the band saw blade in place and turn the
blade tightening lever counterclockwise until it stops.
This places proper tension on the band saw blade.
NOTICE:
Make sure that the band saw blade is
correctly positioned around the wheels.
NOTICE:
Start and stop the tool two or three
times to make sure that the band saw blade runs
properly on the wheels.
To remove the band saw blade, follow the installation
procedure in reverse.
1
3
2
Adjusting the stopper plate position
In the ordinary operation, protrude the stopper plate to
the A side fully.
When the stopper plate strikes against the obstacles
like a wall or the like at the finishing of a cut, loosen two
bolts and slide it to the B side in the figure.
After sliding the stopper plate, secure it by tightening
two bolts firmly.
► 1. Stopper plate 2. Bolts 3. Band saw blade
Installing hook
Optional accessory
CAUTION:
Do not use the hook for other pur-
pose than temporarily hanging the tool. Doing so
may cause the hook come off from the tool and result
in personal injury.
Hook is useful for hanging the tool. Hang the tool on a
pipe vice or other suitable, stable structure.
To install the hook, set the hook alongside the groove
and tighten it with two screws.
► 1. Hook 2. Screws
7 ENGLISH
1
B
A
3
2
1
2
Tabla de contenido
