Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION (continued)
CHARGING
See Figure 2
Battery packs are shipped in a low charge
condition to prevent possible problems.
Therefore, you should charge them
before first use. If the charger does not
charge your battery pack under normal
circumstances, contact ProTeam Customer
Service.
Charge time is dependent upon the type
of battery pack and the existing level of
charge.
•
Make sure the power supply is normal
household voltage, 120 volts, AC only,
60 Hz.
•
Connect the charger to a power
supply.
•
Attach the battery pack to the
charger by aligning the raised ribs on
the battery pack with the grooves in
the charger, then slide the battery
pack onto the charger.
•
Press down on the battery pack to
be sure contacts on the battery pack
engage properly with contacts in the
charger.
•
Do not place the charger in an area
of extreme heat or cold. It will work
best at normal room temperature.
•
The battery pack will become slightly
warm to the touch while charging.
This is normal and does not indicate a
problem.
•
After charging is complete, the green
LEDs will remain on while the charger
is in Maintenance mode.
•
After completing Maintenance mode,
the green LEDs will begin fading
on/off continuously. This indicates
the battery is fully charged and the
charger is in Energy Save mode.
•
Charger will periodically wake
from Energy Save mode to ensure
the battery pack remains in a fully
charged state.
•
To remove the battery pack from the
charger, pull up on the battery pack.
ProTeam
CHARGING A HOT
BATTERY PACK
When using a tool continuously, the
battery pack may become hot. A hot
battery pack may be placed directly
onto the charger port but charging will
not begin until the battery temperature
cools to within acceptable temperature
range. When the battery pack cools,
the charger will automatically begin
charging.
CHARGING A COLD
BATTERY PACK
A cold battery pack may be placed
directly onto the charger port but
charging will not begin until the
battery temperature warms to within
acceptable temperature range. When
the battery pack warms, the charger will
automatically begin charging.
Figure 2
7
Capítulos
Tabla de contenido
