Maintenance / Cleaning; Troubleshooting - Vortice TELENORDIK 5TR Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

3) Test the ceiling fan functions, by pressing buttons

(1 - 2 - 3 - 4 - 5) on the remote control transmitter,

according to the speed, and test the reversing

function using the

will flash and a beep will sound to confirm that the

command has been received).

4) Test the fan light on/off function (if there is one),

by pressing

on the transmitter.

5) Press "0" on the transmitter to stop the fan; if

necessary, press

again to turn off the fan light.

Check any other switches, inverters and buttons, to

ensure the whole system is working properly.

Timer function

This remote control is equipped with a timer function,

allowing the fan to be operated at the speed and in

the direction selected for approximately 1 hour.

To start the timer function, turn the fan on and press

. The green LED on the receiver will light up to

indicate that the function has been activated. This

green LED will remain lit while the timer is in

operation (approx. 1 hour). After this it will go out.

To start a new timer cycle, select the function again

by pressing

buttons (the red indicator light

If desired, you can change fan speed and/or

direction after the timer function has been started;

this action will not affect the timer period, which will

still be approximately 1 hour.

If you wish to stop the timer function before the end

of the period set, simply press "0".

When the appliance is turned off by pressing "0", all

functions except the light will be switched off.

The reception distance between transmitter and

receiver (with fully charged batteries in the

transmitter) is approximately 13 m.

When installing a number of fans with TELENORDIK

5TR, it is recommended that the appliances be fitted

at least 3 m from each other.