EN
INqUIRING FUNCTION
Checking the current power: In any cooking state of microwave, grill and combination, press
29
Micro./Grill/Combi. once. The current power appears on the display for 2 to 3 seconds.
Checking the current time: In any cooking state, press Clock/Pre-Set once. The current time
30
appears on the display for 2 to 3 seconds.
Checking the pre-set time: Press Clock/Pre-Set once. The pre-set time flashes for
31
2 to 3 seconds. Then, the appliance resumes the clock display.
CLEANING AND CARE
Warning: Cleaning the microwave oven is a significant part of the safe operation of the device and will
prevent health hazards.
Prior to each cleaning: Switch off the microwave oven and disconnect the power plug.
32
The device must be cleaned periodically, food residue must be removed. If the device is not cleaned
regularly, it can cause wear to the surface and severely reduce the service life. Furthermore, it could
result in limited safety and functionality of the device.
• If the door sealing no longer closes reliably due to accumulated food residue, microwave radiation
may leak and damage your health.
• Clean the device after use to prevent mould, vermin, as well as leaking microwave radiation.
• Do not use steam cleaners to clean the device! The steam is pressurized and can condensate on the
electrical components inside the device and cause short-circuits.
• Do not use any abrasive cleaning agents or metal scrapers to clean the door since they could scratch
the surface and cause the glass to shatter.
• Clean the casing with a slightly damp cloth. Please be sure that no water enters the appliance.
• Use a damp cloth to regularly and carefully clean the door sealing, cavity and any adjacent
components. Use a damp cloth to wipe off any food residue or splashes.
• The control panel and its controls must never get wet. Clean with a soft, damp cloth. Leave the door
open when cleaning the control panel in order to prevent accidental operation.
• If steam condensates or forms drops inside the microwave or on the casing, use a soft cloth to wipe it
off. Condensation can occur if moist air meets a cold surface. At very high temperatures, oil and grease
can also evaporate and deposit as a grease film after cooling off.
• The glass tray can be removed for cleaning. Clean the tray in warm, soapy water or in the dishwasher.
• The turntable roller and the cavity bottom should be cleaned regularly to prevent excessive noise.
Use a mild household cleaner to wipe the surface; allow it to dry. If the turntable roller is removed for
cleaning, re-insert it before next use. Regularly clean the door, window and sealing with a damp cloth
to remove dirt.
• Odours in the cavity can be neutralized by filling a microwave-suitable cup with water and lemon juice
and boiling it in the microwave oven for 5 minutes. Wipe the cavity dry afterwards using a soft cloth.
• In the event that the light bulb inside the cavity must be replaced, please contact qualified service
personnel.
IM_OMW 2221 DS_141112_V06.indb 38
38
11/12/14 11:03 AM