Distribution Of Fine Seeds - GASPARDO PA1 Empleo Y Mantenimiento

ENGLISH
USE AND MAINTENANCE

DISTRIBUTION OF FINE SEEDS

Distribution of quantities lower than 3 kg/ha.
During the dosing test the number of gearbox revolutions is low
because the quantity of product to be distributed is small. This can
result in irregular distribution of the product. If the operator notes
this, he should follow the instructions below.
Considering that every section (A, Fig. 316) of the dosing roller
distributes 20% of the product contained in roller itself, the number
of operating sections can be increase and the gearbox rotation
speed to reduce to obtain more homogeneous distribution.
First, take the dosing roller off the machine. Then, unscrew the
knob (B, Fig. 316) using the supplied wrench and remove the lock
nut (C). Extract the section(s) to be activated and put them back in
their positions (1-2-3-4-5, Fig. 316) turning them by 180°.
When re-assembling the sections, make sure that during operation
the dosing grooves of the active sections are staggered from one
another (D, Fig. 316). This will give continuity to distribution.
Re-position the lock nut, tighten the knob using the supplied wrench
and assemble the roller back on the machine.
Block the cleaning element in the operating position and make
sure that the springs hook the previously excluded sections (E,
Fig. 316) preventing their rotation and consequently distribution.
Carrying out the dosing test. To rotate the dosing devices, follow
the instructions provided in the Operation and Maintenance Manual
of the Electrical Distribution Control, and make sure that the real
number of operating sections is coherent with the 1 section roller.
To start distribution again using some of the sections or all of them
disassemble the roller and its parts and put them back in their
original position.
g. 316
B
A
C
E
D
5
4
3
2
1
EN - 59
cod. G19504090