Cleaning Procedures - JENN-AIR JEC9530BDB Manual De Uso

C
& C
ARE
C P
LEANING ROCEDURES
CAUTION
• Be sure appliance is off and all
parts are cool before handling or
cleaning. This is to avoid damage
and possible burns.
• To prevent staining or discoloration,
clean appliance after each use.
• If a part is removed, be sure it is
correctly replaced.
C K
ONTROL NOBS
• Remove knobs in the OFF position by
pulling up.
• Wash with warm, soapy water, rinse
and dry. Do not use abrasive cleaning
agents or abrasive pads as they may
scratch the finish.
• Do not soak.
• Knobs may be cleaned in the dish-
washer. Remove any water marks with
hot soapy water to prevent permanent
stains.
• After replacing the knobs, turn on
each burner to be sure the knobs have
been correctly replaced.
C – G -C
OOKTOP LASS
Never use oven cleaners, chlorine bleach,
ammonia or glass cleaners with ammonia.
NOTE: Call an authorized servicer if the
glass-ceramic top should crack, break or if
metal or aluminum foil should melt on the
cooktop.
• Allow the cooktop to cool before
cleaning.
• General – Clean cooktop after each
use, with a damp paper towel and
Cooktop Cleaning Creme (Part No.
20000001)**. Then, buff with a clean dry
cloth.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR (1-800-536-6247).
LEANING
NOTE: Permanent stains will develop if
soil is allowed to cook on by repeatedly
using the cooktop when soiled.
• Heavy Soils or Metal Marks –
Dampen a "scratchless" or "never
scratch" scrubber sponge. Apply
Cooktop Cleaning Creme* (Part No.
20000001)** and scrub to remove as
much soil as possible. Apply a thin
layer of the creme over the soil, cover
with a damp paper towel and let stand
30-45 minutes (2-3 hours for very heavy
soil). Keep moist by covering the paper
towel with plastic wrap. Scrub again,
then buff with a clean dry cloth.
NOTE: Only use a CLEAN, DAMP
"scratchless" pad that is safe for
non-stick cookware. The pattern
and glass will be damaged if the
pad is not damp, if the pad is soiled,
or if another type of pad is used.
• Burned-on or Crusty Soils – Scrub
with a "scratchless" or "never scratch"
scouring pad and Cooktop Cleaning
Creme*. Hold a razor blade
scraper at 30° angle and
scrape
remaining soil.
ERAMIC
Then, clean as
d e s c r i b e d
above.
NOTE: Do not use the razor blade
for daily cleaning as it may wear the
pattern on the glass.
• Melted Sugar or Plastic –
Immediately turn element to LOW and
scrape sugar or plastic from hot surface
to a cool area. Then turn element OFF
and allow to cool. Clean residue with
razor blade scraper and Cooktop
Cleaning Creme*.
any
8
S S
TAINLESS TEEL
( )
SELECT MODELS
• DO NOT USE ANY CLEANING
PRODUCT CONTAINING CHLORINE
BLEACH.
• ALWAYS WIPE WITH THE GRAIN
WHEN CLEANING.
• Daily Cleaning/Light Soil –– Wipe
with one of the following - soapy water,
white vinegar/water solution, Formula
409 Glass and Surface Cleaner* or a
similar glass cleaner - using a sponge or
soft cloth. Rinse and dry. To polish and
help prevent fingerprints, follow with
Stainless Steel Magic Spray (Jenn-Air
Model A912, Part No. 20000008)**.
• Moderate/Heavy Soil –– Wipe with
one of the following - Bon Ami, Smart
Cleanser, or Soft Scrub* - using a damp
sponge or soft cloth. Rinse and dry.
Stubborn soils may be removed with a
damp Scotch-Brite* pad; rub evenly with
the grain. Rinse and dry. To restore
luster and remove streaks, follow with
Stainless Steel Magic Spray*.
• Discoloration –– Using a damp sponge
or soft cloth, wipe with Cameo Stainless
Steel Cleaner*. Rinse immediately and
dry. To remove streaks and restore luster,
follow with Stainless Steel Magic Spray*.