Charging Battery - OK. OPD 910 Manual De Instrucciones

REPLACING REMOTE CONTROL BATTERY
1 Push in direction of arrow and slide battery holder out.
2 Remove old battery if any. Insert 1 x battery (Type CR2025) in the battery compartment. Make sure
the polarity is correct as indicated.
HEADPHONES
Connect earphones to the headphone jack if desired.
3
VOLUME ADJUSTING
Set desired volume on the DVD player or remote control.
4

CHARGING BATTERY

Make sure the power switch is set to OFF. 5
Plug the power adapter cable into the DC IN jack.
6
Connect the adapter to a suitable power outlet.
7
During charging: Charge LED is flashing green.
8
Full battery: Charge LED will turn green.
Note: Charge battery for at least 4 hours before using first time! If the built-in battery power is low. Low
Battery is shown flashing on screen, then the player will turn itself off automatically.
The DVD player can also be permanently powered by the AC/DC adapter and charger independent from
the battery charging level.
CONNECTING TO A TV
Use AV cable to connect AUDIO and VIDEO outputs to respective inputs of TV.
9
USING THE CAR ADAPTER
10 The product is supplied by 12 V only. DO NOT connect to 24 V on board power supplies or adapters.
SCREEN ROTATION
11 Rotate the screen clockwise. Flip over the screen to use as a tablet.
DISC PLAYBACK
12 Slide the ON/OFF switch to ON position to turn on the DVD player.
button to open the disc compartment and insert a DVD.
13 Press
14 Close disc compartment. Playback will start automatically.
Note: Some discs may start automatically. If no disc is inserted, the display will show No disc. If the
playback does not start automatically, press SOURCE button and choose DVD mode.
IM_OPD910_161214_V03_HR.indb 27
27
EN
14/12/16 5:46 PM