General Maintenance; Maintenance - Arctic Cove 500 CFM Manual Del Operador

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always disconnect the
unit from the power supply when cleaning or performing
any maintenance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
WARNING:
Always completely drain water tank when not in use
to prevent the possible formation of bacteria or mold.
Using a cooler that contains bacteria or mold can result
in serious personal injury or illness. Be careful not to spill
water when draining tank, which can create a slip and
fall hazard.
CLEANING THE FILTER MEDIA
See Figure 14.
For better air quality, inspect and clean the filter media once
a month. Replace if damaged.
WARNING:
With the pump off, run the evaporative cooler fan for 15
to 30 minutes to dry the media. Always thoroughly dry
the media to prevent the possible formation of bacteria
or mold. Circulating air through a media that contains
bacteria or mold can result in serious personal injury or
illness.

MAINTENANCE

 With the pump off, run the evaporative cooler fan for 15
to 30 minutes to dry the filter media.
 Once the filter media is dry, turn the evaporative cooler
off and disconnect it from the power supply.
 Press down on latches to unlock the filter media door.
 Lower the filter media door and remove the filter media.
 Use a clean dry cloth to remove dirt and debris from the
filter media.
 Reinstall the filter media. Make sure the filter media is
seated properly inside the filter media door.
NOTE: Be sure to orient the filter media as illustrated.
NOTICE:
Do not operate the evaporative cooler without the filter
media while the pump is running. Doing so could damage
the motor and reduce performance.
 To secure the filter media door, insert the latch into the
notch. Close the filter media door and push the latch until
it snaps into place.
CLEANING THE FILTER SCREEN
See Figure 15.
 Disconnect the evaporative cooler from the power supply.
 Press down on latches to unlock the filter media door.
 Lower the filter media door and remove the filter media.
 Locate the tabs on the side of the filter screen and pull it
up and away from the filter media door.
 Using a soft brush, clean away any dirt or debris.
 When clean, replace the filter screen and filter media and
close the filter media door.
NOTICE:
Do not operate the evaporative cooler without the filter
screen in place. Doing so will allow contaminates to enter
the filter media.
10 — English