Assembly; Installing The Casters - Arctic Cove 500 CFM Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts in the Includes list
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.

ASSEMBLY

WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

INSTALLING THE CASTERS

See Figure 3.
 Carefully lower the evaporative cooler until it rests on its
back or side.
 Push casters into the grommets located at the base of
the unit until they snap into place.
NOTE: The locking casters should be installed in the
front grommets, which are on the side closest to the fan
louvers.
 Make sure the casters are secure, and then return the
evaporative cooler to the upright position.
INSTALLING BATTERIES INTO REMOTE
CONTROL
See Figures 4 - 5.
 Remove the battery cover from the remote control.
 Install AAA batteries according to the polarity indicators
(+ or –) inside the battery compartment.
 Replace and secure the battery cover.
NOTE: If the remote becomes difficult to use or will not
work at all, the batteries may need to be replaced.
 Place the remote control into the remote storage area.
7 — English