Overview Of Using Studio Flash Unit Bl200/Bl400 - Metz Mecastudio BL-200 Manual De Instrucciones

See picture B.
DIGITAL DISPLAY
shows the value of the set flash output or
modelling lamp.
TONE button with LED to switch the flash
ready tone on and off.
SERVO button with LED to switch the
photocell on and off.
MODELLING LIGHT with LED to set the
brightness of the modelling lamp.
PLUS button to increase the flash output
TEST button to trigger a test flash with
FLASH READY LED.
The LED illuminates when a flash can be
triggered with the desired flash output.
MINUS button to reduce the flash output.
Clamping screw to hold the lamp shade.
Holder for lamp shade.
Clamping screw for the tilt of the studio
flash unit.
Tripod holder with clamping screw.
4 Overview of using studio flash
unit BL200/BL400
Chapter 5 to chapter 12 describe
• how to safely setup and put the studio
flash unit into operation (chapter 5).
• how to set the studio flash unit (chapter 6).
• different possibilities for flash synchroni-
sation (chapter 7).
• the warning tone in the event of overhea-
ting (chapter 8).
• how to use the lamp shade (chapter 9).
• how to transport and store the studio flash
unit (chapter 10).
• how to clean and maintain the studio flash
unit (chapter 11).
• how to resolve any problems that may arise
yourself (chapter 12).
The concluding chapters 13 to 15 inform you
about the following:
• technical data of the BL200 / BL400 studio
flash unit.
• spare parts and accessories.
• disposal and environmental protection.
k
65