Installing And Removing The Battery And Card - Canon EOS Rebel T3 Manual Basico De Instrucciones

Installing and Removing the Battery and Card

Load a fully-charged Battery Pack LP-E10 into the camera. The card
(sold separately) can be an SD, SDHC, or SDXC memory card. The
captured images are recorded onto the card.
Make sure the card's write-protect switch is set upward to
enable writing/erasing.
Installing the Battery/Card
Write-protect switch
22
Open the cover.
1
Slide the lever as shown by the
arrows and open the cover.
Insert the battery.
2
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
Insert the card.
3
As shown in the illustration, face
the card's label side toward the
camera back.
Insert the card straight in all the way.
Close the cover.
4
Press the cover until it snaps shut.
When you set the power switch to
<1>, the number of possible shots
(p.26) will be displayed on the LCD
monitor.