Selecting A Frequency From A Group; Scan Function - Monacor JTS UF-10R/12 Manual De Instrucciones

6.2.2 Selecting a frequency from a group

The easiest way to operate several audio trans -
mission systems at the same time is to select the
frequencies for the systems from one of the
12 groups.
1) Call up the group and channel selection via the
menu item
menu.
Setup Group
G: 7 CH:22
650.575 MHz
2) Turn the knob PUSH / CONTROL to select the
group.
3) Press the knob once to highlight the channel
number. Then turn the knob to select the chan-
nel. The corresponding receiving frequency is
indicated in the bottom line.
4) Press the button SETUP to save the setting.

6.2.3 Scan function

Before a transmission channel is selected, the scan
function can be used to determine if other trans-
mission systems are transmitting on the channels
of the UF-10R / 12 at the same moment. The chan-
nels already used will be skipped during channel
selection.
1) Call up the selection menu for scanning via the
Scan
menu item
1. All Groups
2. Result List
3. Current Group
4. Return
2) It is possible to scan the channels of all groups
( table on page 36, 37) [this will take a few
minutes] or only the channels of one group (this
is faster).
Scanning all channels
1) Select the menu item
this has not been done already. Then press the
knob PUSH / CONTROL.
Scan All Groups
Press Setup or Enter to
start scan.
Press Exit to quit.
16
Group/Channel
of the main
of the main menu.
All Groups
2) Press the button SETUP or the knob PUSH /
CONTROL to start scanning. The display shows
Scanning...
To exit at any time, press the button EXIT.
3) After scanning, the result list appears showing
all free channels:
Scan Result List
G:
Open Channel : 46
Group 1 has been selected. The bottom line indi-
cates the number of free channels, in this case
Fig. 9
46 channels. In group 1, 48 channels are avail-
able, i. e. 2 channels are already being used.
4) All 12 groups can be selected when you turn the
knob PUSH / CONTROL.
5) To select a free channel, press the knob PUSH /
CONTROL so that the channel number is high-
lighted. Then turn the knob. When you turn the
knob, the channels already used are skipped.
6) Press the button SETUP to store the channel
selected for reception.
Scanning the channels of a group
1) If the selection menu for scanning (fig. 10) is not
shown, call it up via the menu item
main menu.
2) Turn the knob PUSH / CONTROL to select the
menu item
knob.
G:
Fig. 10
3) Turn the knob PUSH / CONTROL to select the
group.
4) Scanning of a group will always start with the
first channel which is automatically selected. To
check the first channel, press the knob PUSH /
CONTROL. After the check, the display will
show
(fig. 10), if
nel is not already being used. If the channel is
being used, it will be skipped and the next free
channel will be indicated.
5) To check the next free channel, press the knob
PUSH / CONTROL once again.
6) Press the button SETUP to store the channel for
reception. Fig. 11
%
.
1 CH: 1
Current Group
Scan Current Group
1 CH: 1
OK
after the channel number if the chan-
Fig. 12
Scan
of the
. Then press the
Fig. 13