Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALL SANDING SLEEVES
ONTO SPINDLES
FOR 1/4", 1/2", & 5/8" SPINDLES
• Loosen the Phillips head screw on the bracket clamp located
at the bottom of the spindle. See Figure 2.
• Slide the sanding sleeve onto the spindle completely,
ensuring the sleeve slides under the bracket clamp as shown.
• Re-tighten the screw on the bracket clamp to secure the
sleeve in place.
• To ensure the sleeve is secure on the spindle, pull on the
sleeve to make sure it does not slide.
FOR 1 ½" & 2" SPINDLES
NOTE: The threads at the top of the 1 ½" and 2" spindles are
reverse threaded. To tighten the nut at the top of the spindle
during steps 2 and 3, turn counter clockwise.
• Slide the sanding sleeve onto the spindle, ensuring the
bottom edge of the sleeve is even with the bottom edge of
the spindle.
• Using the 12 mm wrench (supplied) tighten the nut on
the top of the spindle by turning counter clockwise. See
Figure 3.
• To ensure the sleeve is secure on the spindle, pull on it. If the
sleeve slides on the spindle, continue tightening the nut at the
top in ½-turn increments as needed.
INSTALL SPINDLES
NOTE: Reverse threads are used to attach the spindle to
the machine.
Make sure that the switch is in "OFF"
position and that the power cord is
unplugged.
• If installed, remove the table insert to allow better
access the spindle seat.
• Using a 17 mm wrench to hold the spindle seat
stationary, screw the bottom threads of the spindle into
the spindle seat counter clockwise until hand tight.
• Use a second 17 mm wrench, placed over the retaining
nut on the spindle (see Figure 4), to tighten the spindle
no more than another ½ turn.
NOTE: Do not over tighten the spindle as this can make
it difficult to remove later.
ASSEMBLY
TOOLS REQUIRED
• 12mm wrench
• Phillips head screw driver
FIGURE 2
8
FIGURE 3
FIGURE 4
Tabla de contenido
