Charging The Batteries - Facom CL2.BA19 Manual De Instrucciones

Charging the batteries:
Your new batteries will reach their full capacity only after about 3 ''charge-discharge '' cycles.
Charging the battery:
- Press the release button (mark V)
on the battery to release it from the machine.
- Slide the battery to the front of the machine.
- Connect the charger to mains (100 - 240 V
1
When you plug the charger, the green indicator
blinks.
3
The battery is charged properly.
The green
indicator is lit.
Disconnect the charger.
- Slide it to pull the battery out from the charger.
- Re-engage the battery firmly onto the machine.
Charger :
- Your charger can be sued to charge FACOM batteries, 19.2 Volts Li-Ion only.
Charging conditions:
- To ensure the best possible charge, the battery charger has a temperature sensor (NTC) authorising charging between
0˚C and 45˚C.
- If the battery has been stored at a temperature below 0˚C, allow it to warm up to room temperature before charging it.
- If a battery is too hot after prolonged use, allow it to cool down for a few minutes before charging it.
V
).
AC
Push the battery fully onto the charger by sliding it in the direction
2
shown by the arrow.
The battery is charging,
the red indicator is lit.
If the 2 indicators lit :
- the battery either does not comply or is faulty,
- or the charger is faulty.
Contact your retailer
The charger is waiting as the
battery temperature is not
adapted to the charge, the
red indicator blinks.
7