Rothenberger ROCAM mobile color Instrucciones De Uso página 19

The equipment can function independent of the
mains for approx. 2.5 hours with a fully charged
battery.
New batteries reach their full capacity after 4-5
charge and discharge cycles. Batteries which have
not been used for a long time should be recharged
before use.
Temperatures in excess of 50°C reduce the
battery's performance. Avoid long periods of
exposure to sun or heat.
Operating controls/displays
Rotary ON/OFF knob:
Battery-charge- warning-lamp
Metre counter (optional): overlay of distance
already travelled by camera on monitor. Reading
can be forwards or backwards. Can be zeroed at
any point with the reset button.
During initialisation immediately after
switching
on there may, in certain circumstances, be
indeterminate
inserts. If this is the case, switch off the
equipment and wait for approx. 5 seconds
before switching it back on.
Changing the battery
Insert battery in the fixture on the rear until it
latches into place. To remove, press both catches
and extract battery.
Connecting recording equipment
Tube inspections can be documented with external
recording equipment.
Videorekorder mittels Scartkabel anschließen.
During recording "button
During playback via the ROCAM® screen display
" in Position =.
"button
Connect computer by means of USB cable..
During recording"button
Cleaning
It is essential to clean the equipment after every
tube inspection.
Switch off the equipment, remove the battery and,
where applicable, disconnect the power supply
unit.
Device on/off,
Lighting control
- Output video signal
= Input video signal
red -> fast charge
green -> float charging
chi
" in position -.
" in position -.
Close the cover ensuring that it locks into place.
Clean the reel cable on the base with water (spray
jet).Clean the camera head with water (spray jet)
before inserting it into the bracket.
Never aim the jet of water at the front of
the
quipment (display screen/control panel).
Operating the equipment
Clean the tube system before inspecting the tubes.
1
Press the button and open the cover,
ensuring that it locks into place.
B
2 Switch on the equipment using the rotary
button.
Switch on the display screen using the
"POWER"button.
3 Remove the camera head from the bracket
and uncoil the reel cable from the reel.
The reel cable is rigid and under mechanical
stress.
Therefore hold the reel cable tight when
uncoiling it from the reel!
4
Insert the camera head in the tube system
and feed it in carefully with the reel cable.
Do not kink the reel cable or pull it over
sharp edges!
Wear protective gloves!
C
For tube ø greater than 80 mm mount the guide
pieces. The guide pieces can be adjusted to the
D
tube ø by cutting off the margins.
The reel cable can form loops while being
fed in constituting a risk of fracture!
The camera picture can turn upside down
while being fed through several bends in the
tube – this is a normal occurrence and does
not mean that the system is defective.
Upon completion of work pull the reel cable out of
the tube and roll it directly onto the reel.
Clean the camera head under flowing water (spray
jet – not pressure jet)
E
Replace camera head in bracket.
Close cover. Display screen switches off
automatically.
ENGLISH
Always stand beside the reel
cable!
F
11