Preparation Of The Appliance; Inserting The Brush - bluematic SD 43 ORBITAL Manual De Uso Y Mantenimiento

To insert the brush/pad holder into the brush head body of the
appliance, proceed as follows:
1. Check that the plug (1) on the power cable (2) has been taken
out of the socket (3) of the mains supply (Fig.1), and if not,
disconnect it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
3. Tip the appliance back (Fig.4), block one of the rear wheels and
shift the control column backwards.
4. Unscrew and remove the fixing lugs and centering plate (Fig.5).
5. Turn the brush/pad holder anti-clockwise to secure it to the hub
(Fig.6). Insert the drive disc, be careful to center the fastening
pins on the machine with the drive holes.
4
7
ATTENTION To obtain a correct tightening of the keys, use a pliers.

PREPARATION OF THE APPLIANCE

INSERTING THE BRUSH / PAD HOLDER
2. Check that the handlebar is in the vertical position, if not, press
the uncoupling lever (4) (Fig.2) and turn the handlebar to the
vertical position (Fig.3). When the handlebar is vertical, release
the uncoupling lever (4).
3
1
2
2
6. Insert the pad holder stop flange (3) (Fig.7)
7. Screw in the tightening keys (2) (Fig.8)
8. Please make sure to tighten the screws very well.
5
3
8
26
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
4
3
Verify tightening screws every few hours during the
use of the machine.
6
2