Tabla de contenido
Idiomas disponibles
Idiomas disponibles
13. NEVER use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
14. NEVER leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
15. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
16. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
17. ALWAYS wear eye protection that meets the requirement of the latest revision of ANSI
18. NEVER leave the orbital sander on floor and so on while spinning.
19. NEVER apply water or lubricating oil, otherwise hazards from electrical shocks may
result.
20. NEVER push the orbital sander too strongly onto a surface.
Pushing the orbital sander too strongly may cause the sanding paper to tear or shorten
the life of the sander itself.
21. ALWAYS operate the orbital sander safely for correct use.
This orbital sander is a portable dry plane surface sander that was designed for finishing
wood and metal surfaces and ground coats.
22. ALWAYS securely installing the sanding paper.
23. ALWAYS wear a protective mask when operating the orbital sander in confined spaces.
24. Definitions for symbols used on this tool
V ............ volts
Hz .......... hertz
A ............ amperes
n
.......... no load speed
o
W ........... watt
........... Class II Construction
---/min ... revolutions per minute
Standard Z87.1.
English
7
Tabla de contenido
