Tabla de contenido
Idiomas disponibles
Idiomas disponibles
E NG LIS H
I. ANTI-TIP TUBES (OPTIONAL)
Sunrise Medical recommends the use of Anti-tip tubes.
1. Inserting Anti-Tip Tubes Into Receiver
a. Press the rear anti-tip release button on the anti-tip tube so that both release pins are drawn inside.
b. Insert into the anti-tip tube receiver (B).
c. Rotate the anti-tip tube until the release pin pops through the receiver mounting hole.
d. Insert the second anti-tip tube the same way.
2.
Turning Anti-Tip Tubes up.
a. Press the rear anti-tip tube release button (A).
b. Hold the button in and turn anti-tip tube up.
c. Release the button
d. Repeat with second anti-tip tube.
e. Remember to return anti-tip tubes to down position after completing maneuver.
3. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or lowered to achieve the proper clearance of
1 1/2" to 2".
a. Press the anti-tip wheel release button () so that both release pins are drawn inside.
b. Raise or lower to one of the three predrilled holes.
c
Release button.
d. Adjust the second anti-tip tube wheel the same way. Both wheels should be at exactly the same
height.
J. FLIP-BACK ARMREST
Flip-back armrests are shipped standard on Breezy Elegance wheelchairs, and installed by Sunrise.
1. To flip armrests back, depress the release latch (D) and rotate arm toward back of wheel-
chair.
K. FLIP-BACK HEIGHT ADJUSTABLE ARMREST
(GOLD AND PLATINUM MODELS )
Flip-back height-adjustable armrests are installed by Sunrise.
1. Height-Adjustment
a. Release the securing lever (2).
b. Slide armpad (1) up or down to desired height.
c. Move the pad up or down slightly until it is locked in place.
2. Flipping Armrest Back and Removing Armrest
a. Depress the release latch (3) and rotate armrest toward
the back of wheelchair.
b. To remove, pull up on armrest. Pin (6) securing armrest
will automatically release.
c. To return armrest to operating position, push armpad
down until it locks into place.
L. SWING-IN/SWING-OUT FOOTREST
1. Installing the footrest
a. Place swing-away pivot saddle (E) into the receiver on front frame tube with the footrest
facing outward from the frame.
b. Rotate the footrest inward until it locks into place on hanger latch block
2. Removing the footrest
a. To remove footrest, pull the release lever toward the frame.
b. As you continue to hold the lever, rotate the footrest outward and lift.
127071 Rev. A
16
17
18
19
20
21
VIII. OWNER USE & MAINTENANCE
Flip-Back Height Adjustable
1. Armrest pad
2. Height adjustment
lever
3. Flip-back release latch
4. Rear receiver
5. Armrest panel
16
16
17
20
21
Capítulos
Tabla de contenido
