To Mount And Remove Rear Wheels; G.wheel Locks; H.drum Brake - Breezy Elegance Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

E NG LIS H
F. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are locked. An unlocked axle may come
off during use and cause a fall.
Note: Axle is not locked until:
a. The quick-release button (A) pops out fully.
b. The ball bearings are fully visible on the outside of the sleeve.
1. To Install Wheel:
a. Depress quick-release button (A) fully. This will release tension on ball bearings at other end.
b. Insert axle through hub of rear wheel.
c. Keep pressure on button (A) as you slide axle (B) into axle sleeve (C)
d. Release button to lock axle in sleeve. Have a dealer adjust the axle if it does not lock.
e. Repeat these same steps on other side.
2. To Remove Wheel:
a. Depress quick-release button (A) fully.
b. Remove wheel by sliding axle (B) out of axle sleeve (C).
c. Repeat steps on other side.
G. WHEEL LOCKS
12
The Breezy Elegance comes standard with a Push to lock wheel lock.
Wheel locks are installed at Sunrise and should only be adjusted by your qualified service person.
Inspect wheel locks weekly per the maintenance chart. Do not use your chair UNLESS you are
sure both wheel-locks can fully engage. A wheel-lock that is not correctly adjusted may allow
your chair to roll, or turn unexpectedly.
Wheel-locks must be fully engaged, the arm (D) should be imbedded into the tire at least 1/8" to
be effective.
If you find the wheel locks have slipped or are not working correctly, contact your service
provider for proper adjustment.
H. DRUM BRAKE (GOLD AND PLATINUM MODELS)
Drum Brakes can be used to control speed when an attendant or caregiver is present. The rider
of this chair should never attempt to use the Brake handles to stop or slow the chair.
Drum Brakes can also be locked, and used as an extra safety measure for keeping the chair sta-
tionary for activities like transfers.
1. Slowing the speed (Attendant)
a. Squeeze the two triggers (F) simultaneously to slow the chair and control the speed.
2.
Locking the drum brake (Attendant)
a. Squeeze the two brake levers and use your index finger to rotate the locking latch (G) into place.
b. Release the levers and check to make sure the chair is locked.
c. Apply Wheel locks if extra stability is needed.
3.
Unlocking the drum brake (Attendant)
a. Squeeze the two brake levers, squeezing the trigger hard enough that the locking latch pops out of the
lock position.
b
You may use the alternate method of squeezing gently and using your index finger to unhook the lock-
ing latch
10
11
WARNING
WARNING
13
14
15
WARNING
15
VIII. OWNER USE & MAINTENANCE
A
10
11
C
B
12
13
E
14
15
127071 Rev. A

Capítulos

Tabla de contenido
loading

Tabla de contenido