Follow These Steps When Battery Is Outside Vehicle; Assembly And Mounting Instructions; Features - Schumacher Electric SP-200 Manual Del Usuario

6.6 For a positive-grounded vehicle, connect
the NEGATIVE (BLACK) clip from the
solar battery maintainer to the NEGATIVE
(NEG, N, -) ungrounded post of the battery.
Connect the POSITIVE (RED) clip to the
vehicle chassis or engine block away from
the battery. Do not connect the clip to the
carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal

7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE

WARNING: A SPARK NEAR THE
BATTERY MAY CAUSE A BATTERY
EXPLOSION. TO REDUCE THE RISK
OF A SPARK NEAR THE BATTERY:
7.1 Check the polarity of the battery posts.
The POSITIVE (POS, P, +) battery post
usually has a larger diameter than the
NEGATIVE (NEG, N, -) post.
7.2 Attach at least a 24-inch (61 cm) long
6-gauge (AWG) (13 mm
battery cable to the NEGATIVE (NEG, N, -)
battery post.
7.3 Connect the POSITIVE (RED) solar
battery maintainer clip to the POSITIVE
(POS, P, +) post of the battery.
7.4 Position yourself and the free end of
the cable you previously attached to the
NEGATIVE (NEG, N, -) battery post as far

8. ASSEMBLY AND MOUNTING INSTRUCTIONS

8.1 Remove all cord wraps and uncoil the
cables prior to using the solar battery
maintainer.
To mount the solar battery maintainer (in
a dry location off the ground):
1. Using the solar battery maintainer as
a template (guide), mark the location
of the four pre-molded mounting holes
on a secure, flat surface.

9. FEATURES

) insulated
2
3
part of the frame or engine block.
6.7 Using the quick-connect connector, plug
the clips into the solar battery maintainer.
6.8 When disconnecting the solar battery
maintainer, unplug the clips from the solar
battery maintainer, remove the clip from the
vehicle chassis, then remove the clip from
the battery terminal.
away from the battery as possible – then
connect the NEGATIVE (BLACK) solar
battery maintainer clip to the free end of
the cable.
7.5 Do not face the battery when making the
final connection.
7.6 Using the quick-connect connector, plug
the clips into the solar battery maintainer.
7.7 When disconnecting the solar battery
maintainer, always do so in the reverse
order of the connecting procedure and
break the first connection while as far
away from the battery as practical.
7.8 A marine (boat) battery must be removed
and maintained on shore. To maintain
it onboard requires equipment specially
designed for marine use.
2. If necessary, drill four 7/64" (0.109)
dia. pilot holes.
3. Mount the solar battery maintainer
using the four stainless steel screws
provided.
NOTE: Do not overtighten the screws
or you will break the plastic frame of the
solar battery maintainer.
1
1. Solar panel
2. Quick-connect 50 Amp battery
clip cable assembly
3. Quick-connect 12V accessory
plug cable assembly
2
6
• •