Assembly; Operation - Ryobi P225 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 Driving screws in drywall
INSTALLING/REMOVING THE BELT HOOK
See Figure 1, page 9.
The belt hook can be installed on either side of the tool.
 Squeeze the prongs together as shown.
 Insert the prongs into the belt hook slot on either side of
the tool.
 When the belt hook is fully inserted into the slot, release
the prongs.
 To remove, squeeze the prongs together and pull the belt
hook out of the slot on the side of the tool.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
 Lock the switch trigger.
 Insert the battery pack into the product as shown.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.

OPERATION

 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
LED LIGHT
See Figure 3, page 9.
The LED light, located on the front of the tool base, illuminates
when the switch trigger is depressed.
The LED light illuminates only when there is a charged bat-
tery pack in the tool.
INSTALLING/REMOVING BITS
See Figure 4, page 9.
To install bits:
 Remove the battery pack.
 Pull the sleeve from the gear casing. The sleeve and
adjustable nosepiece come off the gear casing as a set.
 Push the bit holder into the opening of the spindle until
the ball lock clicks into the groove in the bit holder shank.
 Push the bit into the bit holder.
 Reattach the sleeve and adjustable nosepiece to the gear
case. Align the arrow on the side the sleeve with the arrow
on the gear case and push the nosepiece until it snaps
into place.
To remove bits:
 Remove the battery pack.
 Pull the sleeve from the gear casing. The sleeve and
adjustable nosepiece come off the gear casing as a set.
 Push the bit holder shank toward the gear casing and
remove the bit.
STARTING/STOPPING THE SCREWDRIVER
See Figure 5, page 9.
To turn the screwdriver ON, depress the switch trigger. Re-
lease the switch trigger to turn the screwdriver OFF.
6 — English