Samson EXPEDITION XP300 Manual Del Usuario página 14

XP300 Mixer Layout
8. VOL Control Knobs – These knobs set the overall level for each input channel.
NOTE: To reduce noise, set the VOLUME controls on any unused channels to the minimum
setting.
9. Pairing Indicator – Displays the Bluetooth status of the XP300 system.
10. Pairing Button – Press this button to enable discoverable mode in order to pair with a
Bluetooth audio device.
11. SPEAKER OUT Jacks – The XP300 has two 1/4" phone connectors, which are powered
outputs used to connect your left and right speakers. Use the included speaker cables to
connect the speakers.
CAUTION: The total impedance load for each side of the amplifier must not be less than 8
ohms. Do not connect additional speakers to the XP300 mixer.
12. Effects PROGRAM Selector – This control knob is used to select one of 16, 24–bit DSP
effects programs.
13. EFFECTS Send Knob – The EFFECTS Send knob is used to adjust the total amount of effects
added to the master bus.
14. MASTER Volume Knob – The MASTER volume knob controls the overall output level.
Signals from all six channels are routed here just before being routed to the built-in power
amplifiers and Left and Right Speaker Output jacks.
15. IEC Inlet – Connect the supplied heavy-gauge 3-pin "IEC" power cable here.
16. POWER Switch – Use the POWER switch to turn power to the XP300 on or off.
17. Power/Peak Indicator – This LED will illuminate GREEN when the MAIN power switch is
turned on, and light RED when the when the amp is near the clipping point. If the Peak
indicator lights frequently, turn down the MASTER volume control or turn down the input
channel VOL controls, until the indicator does not light anymore, or lights only occasionally
with signal peaks.
18. SUB OUT Connector – This full-range output is used to send the main mix to an external
active subwoofer. The signal present at this connector is the after the MASTER level
control.
19. Mixer Lock – Turn this quarter turn lock counterclockwise, to the RELEASE position, to
remove the mixer from the rear of the speaker cabinet. When transporting the XP300,
make sure the lock is in the LOCK position.
14