Function "Scan": Skipping Channels Already Being Used When Selecting Channels; Function "Sq": Setting The Squelch Value; Function "Att": Level Attenuation For The Xlr Output; Function "Lock": Key Lock - Monacor JTS US-36G2/5 Manual De Instrucciones

function, the group/channel number will disappear
It will reappear when the receiver is switched on
again
4) To save the setting, press the button SET
6.3 Function "SCAN":
Skipping channels already being used
when selecting channels
When this function is selected,
ing on the display
When the function has been activated, the receiver
will check during channel selection (
ter 6 1, step 3) if this frequency is already being
used for transmission (meanwhile the display will
indicate ) If the channel is being used, the
next free channel will be selected automatically
If the group does not offer any free channel,
the display will indicate
another group
1) To activate the function, use the button
select the setting
To deactivate the function, use the button
to select the setting

2) To save the setting, press the button SET

6.4 Function "SQ": Setting the squelch value

When this function is selected,
letters "SQ" start flashing on the display
The squelch threshold is adjustable The squelch
function will mute the receiver when the level of
the radio signal falls below the threshold value
Thus, interference signals will not cause noise
when the transmitter is switched off or when its
radio signal is poor: If the levels of the interfer-
ence signals are below the threshold value, the
receiver will be muted
A high threshold value offers high interfer-
ence resistance, but it will also reduce the trans-
mission range: If the strength of the radio signal
from the transmitter falls below the value ad-
justed, the receiver will also be muted
12
starts flash-
☞ chap-
In this case, select
to

and the
1) Use the button

threshold value: The higher the number
(–5 ... +10), the higher the threshold value
2) To save the setting, press the button SET
6.5 Function "ATT":
Level attenuation for the XLR output
When this function is selected,
ing on the display
When the function has been activated, the sig-
nal level at the XLR output will be attenuated by
20 dB and the XLR output can be connected to
a microphone input
1) To activate the function, use the button
select the setting
on the display
To deactivate the function, use the button
to select the setting

2) To save the setting, press the button SET

6.6 Function "LOCK": Key lock

When this function is selected,
ing on the display
Activating the key lock:
1) To activate the function, use the button
select the setting
the display
2) To save the setting, press the button SET
Deactivating the key lock:
1) Keep the button SET pressed for 3 seconds
to call up the setting mode and to select the
function "LOCK"
2) To deactivate the function, use the button
to select the setting
3) To save the setting, press the button SET
or to set the desired

starts flash-

; "ATT ON" will appear
starts flash-

; "LOCK" will appear on
to
to
