Installation; Overview; Identification Of Parts Of The Unit - Soler&Palau UTBS Serie Instrucciones De Uso

6. INSTALLATION

6.1. OVERVIEW

• The technician responsible for equipment receipt must ensure that the characteristics of the
existing power supply agree with the electrical data on the unit's identifi cation plate.
• Before installing the equipment in its fi nal position, make sure that the place where it will be
located is strong enough to support its weight.
• Under no circumstances should these units be installed in fl ammable or explosive environ-
ments, in environments that contain oil vapours, salt air, or corrosive environments.
• Equipment installation can present hazards due to the material used, pressures in the sys-
tem and the electrical components. For this reason, only trained and qualifi ed service per-
sonnel may install service or repair the equipment.
• As a precaution, when performing operations inside the equipment, shut off the power at a
main breaker. This serves to prevent any accidents involving the equipment's moving parts,
which can start accidentally, well as to prevent any direct or indirect contact with live parts.
• When installing the unit, it must be levelled to allow for a good fi t between the different
modules, perfect condensate drainage and proper opening of the doors.
• To test whether the fan is in perfect condition, check the centering of the intake ring by
turning the impeller by hand.

6.2. IDENTIFICATION OF PARTS OF THE UNIT

The main module may consist of three different sections: fi lter, coils and fans. However, one of
the fi rst two sections may not be included. The following illustration identifi es the main com-
ponents of the main module.
30