Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A
S
SSEMBLING THE
TAND
Before assembling the mixer, be
sure the speed control dial is in the
OFF position and the electric cord
is unplugged.
A
T
TTACHING THE
URNTABLE
Place the revolving turntable into
the base of the stand by pressing the
turntable into the center hole of the
adjustment slot until it snaps into place.
A
T
DJUSTING THE
URNTABLE
The turntable must be adjusted
depending upon which bowl size is
being used (see "Adding the Mixing
Bowl"). To adjust, press down on the
turntable locator switch and slide switch
to the proper icon.
Ball Bearing
Extension
Attaching and Removing the Mixer Head
To attach the mixing head, press in on
the mixer-release trigger, located at the
rear of the stand.
Place the mixer head on the stand so
that the metal pivot on the bottom of
the mixer head goes into the latched
opening on the top of the stand.
Mixer
Head
Mixer-Release
Trigger
As you release pressure from the
M
IXER
mixer-release trigger, the top of the
latch should clamp around the
metal pivot. Once the mixing head
is lowered into position, it will lock
into place.
To raise the mixing head, press the
head lock button downward while
pulling up on the handle of the mixing
head. Once unlocked, the mixing head
can be removed by pressing the mixer
release trigger.
Be sure the mixer head is securely
in position before using.
NOTE: This mixer is NOT intended
for use away from the stand.
A
DDING THE
Move the turntable locator switch to the
proper setting - the large bowl icon if
you are using the large bowl; the small
bowl icon if you are using the small
bowl. Place the desired mixing bowl
onto the turntable.
Mixing bowls should NEVER be used in
a conventional oven, microwave oven,
on top of the range or on any other
heated surface.
If mixing bowls are scratched
Metal
or chipped, do not use mixer. Mixer
Pivot
bowl should not be used to blend in
hot liquids.
Stand
5
Latched Opening
Mixer-Release
Trigger
M
B
IXING
OWL
Tabla de contenido
